Clip In Section: A 59mm wide keel with a 12mm centre that the furring channel clips into.
Two Bottom Flanges: Two 29.5mm bottom flanges give the carrier keel its bearing face.
One Pass Operation: Keel forming and cutting run as one line.
Matched Drive: A 4KW motor with a six point double row chain drive carries the line.
60mm Shafts: Shafts sized to the keel width and the strip class you run.
Set From Panel: Running length and batch count are set from the control panel.
Drawing Matched: Keel width, flange width and centre height follow your drawing.
| Component | Specification |
|---|---|
| Machine type | Clip in ceiling keel roll forming machine |
| Profile | Clip in ceiling carrier keel |
| Model | HY59 |
| Effective width (top width) | 59 mm |
| Bottom width | 59 mm |
| Section | Two 29.5 mm bottom flanges with a 12 mm centre |
| Coil feed width | [To be confirmed] |
| Forming stations | [To be confirmed] |
| Middle plate | [To be confirmed] |
| Frame | [To be confirmed] |
| Shafts | 60 mm |
| Main motor | 4 KW |
| Chain drive | Six point double row |
| Sheet thickness | [To be confirmed] |
| Cutting | [To be confirmed] |
| Control system | [To be confirmed] |
| Running speed | [To be confirmed] |
| Line length | [To be confirmed] |
Clip In Carrier Keel: A 59mm keel with a 12mm centre so the furring channel clips straight onto it.
Two Bottom Flanges: Two 29.5mm flanges form the bearing face of the carrier keel.
One Pass Operation: Keel forming and cutting run as one line.
Matched Drive: A 4KW motor and a six point double row chain drive matched to the keel section.
60mm Shafts: Shafts sized to the keel width and the strip class you run.
Set From Panel: Length and batch count are entered on the control panel.
Drawing Matched: Keel width, flange width and centre height follow your section drawing.
